Wrangler L6-4.0L VIN S (2000)
(20 in. lbs.).
3. Align the radiator mounting brackets to the sides of the grille panel. Install the six screws that secure the radiator and shroud unit to the grille
panel. Tighten the screws to 8 Nm (72 in. lbs.).
4. Install the upper condenser air seal to the top of the grille panel with three retainers.
5. Remove the tape or plugs from the condenser and the inlet and outlet jumper tube refrigerant line block fittings. Reach through the grille opening
from the front of the vehicle to install the inlet and outlet jumper tube block fittings to the condenser with two screws. Tighten the mounting screws
to 12 Nm (105 in. lbs.).
6. Install the two screws that secure the lower condenser bracket to the bottom of the grille panel. Tighten the screws to 2.2 Nm (20 in. lbs.).
7. Install the lower condenser air seal to the bottom of the grille panel and the passenger side frame rail with three retainers.
8. Connect the battery negative cable.
9. Evacuate the refrigerant system.
10. Charge the refrigerant system.
NOTE: If the condenser is replaced, add 30 milliliters (1 fluid ounce) of refrigerant oil to the refrigerant system. Use only refrigerant oil of the
type recommended for the compressor in the vehicle.
