Wrangler L6-4.0L VIN S (2000)
Blower Motor Relay: Service and Repair
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel.
Blower Motor Relay Remove/Install
3. Locate the blower motor relay through the instrument panel glove box opening. The relay is mounted upright and to the right of the instrument
panel harness.
4. Unplug the blower motor relay from its wire harness connector.
INSTALLATION
1. Install the blower motor relay by aligning the relay terminals with the cavities in the wire harness connector and pushing the relay firmly into
place.
2. Reinstall the glove box in the instrument panel.
3. Connect the battery negative cable.
4. Test the relay operation.
