Wrangler L6-4.0L VIN S (2000)
PDC Relay Cassette
1. Remove the relay wedge from the PDC relay cassette to be removed.
NOTE: It may be necessary to remove relay cassettes that are not being serviced from the PDC housing in order to obtain sufficient clearance to
service the faulty relay cassette. The same service procedure is repeated as necessary to remove each of the interfering relay wedges and relay
cassettes from the PDC housing.
PDC Relay Cassette Latches - Typical
2. From the top of the PDC housing, use a small screwdriver or a terminal pick tool (Special Tool Kit 6680) to release the two latches that secure the
relay cassette in the PDC.
3. Gently and evenly press the relay cassette down through the PDC housing.
PDC Relay Cassette Remove/Install - Typical
4. From the bottom of the PDC housing, remove the relay cassette from the PDC.
CAUTION: Do not remove the wiring and terminals from the terminal cavities of the faulty PDC relay cassette at this time. Refer to the
Assembly procedure that follows for the proper procedures for transferring the wiring and terminals to the replacement PDC relay cassette.
