Wrangler L6-4.0L VIN S (2000)
Fig. 11
6. If new sensor was installed, push cardboard spacer on sensor face against tone ring. Then tighten sensor bolt to 12-14 Nm (106-124 in. lbs.).
Correct air gap will be established as tone ring rotates and peels spacer off sensor face.
7. Secure the rear sensor wires to the retainer clips. Verify that wire is clear of rotating components.
8. Connect sensor wire to harness connector.
9. Install brake drum and wheel and tire assembly.
10. Lower vehicle.
11. Connect sensor wire to harness connector.