Wrangler L6-4.0L VIN S (2000)
Power Distribution Center (PDC): Service and Repair
Power Distribution Center Assembly
Power Distribution Center Components - Typical
The Power Distribution Center (PDC) cover, the PDC housing lower cover, the PDC relay wedges, the PDC relay cassettes and the PDC B(+) terminal
stud module are available for service replacement. The PDC cover can be simply unlatched and removed from the PDC housing without the PDC being
removed or disassembled. Service of the remaining PDC components requires that the PDC be removed from its mounting and disassembled.
PDC Relay Cassette
1. Move the faulty PDC relay cassette with its wiring away from the bottom of the PDC housing far enough to allow the replacement relay cassette to
be installed into the PDC.
2. Using the faulty relay cassette as a guide, be certain that the replacement relay cassette is correctly oriented before installing it into the PDC
housing.
3. From the bottom of the PDC housing, align and insert the replacement relay cassette into the PDC. Press the relay cassette up into the PDC until
both of the latches are fully engaged.
CAUTION: Proper care must be taken to be certain that the wiring and terminals from the faulty PDC relay cassette are installed in the correct
terminal cavities of the replacement relay cassette. To prevent mistakes it is recommended that the wiring and terminals be removed from the
faulty relay cassette one cavity at a time, repaired or spliced as necessary, then installed securely into the correct cavity of the replacement relay
cassette.
