Wrangler L6-4.0L VIN S (2000)
Stabilizer Bar: Service and Repair
Front
REMOVAL
1. Remove upper link nuts and separate the links from the stabilizer bar with Remove MB-990635.
2. Remove front bumper valence.
3. Remove stabilizer retainer bolts and remove retainers.
4. Remove stabilizer bar.
5. Remove lower link nuts and bolts and remove links.
INSTALLATION
1. Center stabilizer bar on top of the frame rails and install retainers and bolts. Tighten bolts to 54 Nm (40 ft. lbs.).
2. Position links on axle brackets and into the stabilizer bar. Install lower link bolts and nuts and tighten to 95 Nm (70 ft. lbs.).
3. Install upper link nuts and tighten to 61 Nm (45 ft. lbs.).
4. Install bumper valence.
