Wrangler L6-4.0L VIN S (2000)
the latch in this position.
2. Remove the wiper arm from the motor output shaft using a rocking motion.
Rear Wiper Arm Installation
3. Install the rear wiper arm with the wiper motor in the Park position. Place the rear wiper blade on the lift glass so that it is parallel to or tipped
down from the upper edge of the lift glass a maximum of 80 mm (3.14 in).
4. Lift the wiper arm away from the lift glass slightly to relieve the spring tension on the latch. Push the latch into the locked position and slowly
release the arm until the wiper blade rests on the lift glass.
5. Operate the wiper with the lift glass wet, then turn the wiper switch to the Off position. Check for the correct wiper arm positioning and
readjust if required.