Wrangler 2WD V6-3.8L (2008)
a. Access the tow bar retainer nuts by sliding the front bumper closeout panel to the side opposite the mounting bracket being removed (Figure 5).
b. Attach a 3/4 inch wrench to the top tow bar bracket, handle nut and remove the upper attachment bolt (Figure 3).
c. Attach the 3/4 inch wrench to the lower tow bar bracket handle nut and remove the lower attachment bolt (Figure 3).
d. Repeat Steps 7a. through 7c. on the opposite side tow bar mounting bracket.
8. Install the new tow bar mounting brackets and fasteners on both sides of the vehicle using the following procedure:
a. Place a mark on the metal tabs of all four handle nuts at 2-1/4 inches from the nut end. Align the mark on the tab in a vice and bend the tab at a
90 degree angle in the direction opposite the weld nut. Repeat this procedure on all four handle nuts (Figure 6).
b. Insert the four supplied spacers on the four supplied attachment bolts (Figure 6).
