Wrangler 2WD V6-3.8L (2008)
12. Install the supplied cross tube with the supplied Perma pins. The cross tube is properly installed when the words on the warning label are right side
up. Rotate the Perma pin lock tab to a 90 degree angle and lock it in place (Figure 9).
13. Lower the vehicle from the hoist.
14. Return the front bumper closeout panel to its original position and install the two plastic push pins (Figure 1).
15. Provide the customer with the supplied front tow bar installation instruction sheet p/n K6855693, two hitch pins and two hair pins.