Wrangler 2WD V6-3.8L (2008)
15. Disconnect the brake tube at the right front wheel flex hose connector (Figure 8).
16. Disconnect the right front wheel Anti-lock Brake System (ABS) wheel sensor electrical connector located on the top of the right frame rail.
17. Disconnect the right front brake tube from the retainer clips.
18. Remove and discard the lower half of the right brake tube.
19. Place the new lower half brake tube into position.
20. Snap the new brake tube into the front brake tube from the retainer clips.
21. Connect the right front wheel ABS wheel sensor electrical connector located on the top of the right frame rail.
22. Connect the new brake tube to the right front wheel flex hose connector (Figure 8). Tighten the flare nut to 170 in. lbs. (19 N.m).
27. Connect the upper and lower brake tubes at the steering gear. Tighten the connector flare nut to 170 in. lbs. (19 N.m).
23. Place the power steering reservoir into position and install the mounting bolt.
24. Install the air cleaner assembly.
25. Install the engine coolant reservoir bottle onto the radiator shroud and connect the coolant recovery hose to the radiator.
26. Raise the vehicle on the hoist.
