Wrangler 2WD V6-3.8L (2008)
2. If not previously removed, remove and save the master cylinder-to-HCU brake tube (Figure 10).
3. Disconnect the left rear wheel brake tube at the HCU (Figure 10).
4. Remove the brake tube from the brake tube bundle clip located next to the HCU (Figure 10).
5. Lift the vehicle halfway up on the hoist.
6. Remove the left rear wheel.
7. Disconnect the brake tube from the left rear wheel flex hose connector (Figure 11).
8. Separate the brake tube from the plastic retainer located on the frame (Figure 11).
