Wrangler 2WD V6-3.8L (2008)
17.
Using a small blade screwdriver, slightly open the joint slot in the header panel where the soft top fabric will slide into (Fig. 5).
18.
Slide the soft top fabric through the joint slot.
19.
Roll the fabric retainer onto the header panel, and install the two (2) soft top fabric retainer screws to the soft top header panel.
20.
Repeat the above procedure on new front side bow on the other side of the vehicle soft top.
21.
Close the front soft top section.
22.
Slide the left and right front side bow sleeves rearward to lock the side bow knuckles in place.
23.
Latch the soft top latches to the windshield header.
24.
Install the left and right side drip rail retainers.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
