Wrangler 2WD V6-3.8L (2008)
8. Install the new header seal plate by installing fasteners from the center outward as shown in (Fig. 7).
9. Re-secure the header to the support rods in reverse of the removal process as shown from Step # 4 to Step # 2.
10. Raise and install the soft top to the vehicle. It is important to install the soft top in the correct installation sequence as referenced in the Owners
Manual (DealerCONNECT > TechCONNECT > Owner Manuals or Jeep.com > For Owners > Servicing and Operating My Vehicle >
Owner/Service Manuals).
11. Verify the soft top is properly secured against the header seal.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.