Wrangler 2WD V6-3.8L (2008)
3.
Inspect the Freedom Top panels to ensure that they are installed correctly (Fig 1). If not, then note this condition so that the correct procedure for
installing the Freedom Top panels to the hard top can be reviewed with the customer. To ensure that the panels are installed correctly perform the
following steps in order. When installing each Freedom Top panel, always close the windshield latch first.
a.
With both panels removed, carefully install the right side panel onto the hard top.
b.
Make sure the sun visor is folded down and out of the way.
c.
Latch the right header panel latch located at the top of the windshield.
d.
Turn the right side panel rear L-shaped lock (located above the shoulder belt anchorage) so that it fully engages the hard top.
e.
Turn the right side panel rear fastener knob (located on the overhead speaker bar assembly) clockwise until it is tight.
f.
Carefully install the left side panel onto the hard top.
g.
Make sure the sun visor is folded down and out of the way.
h.
Latch the left header panel latch located at the top of the windshield.
i.
Turn the left side panel rear L-shaped lock (located above the shoulder belt anchorage) so that it full engages the hard top.
j.
Turn the left side panel rear fastener knob (located on the overhead speaker bar assembly) clockwise until it is tight.
k.
Turn both center L-shaped locks (2) 50 that they fully engage the right side panel.
4.
Only after verifying Freedom Top is properly installed, Proceed to Test For Water Leak(s).
Test For Water Leak(s)
