Wrangler 2WD V6-3.8L (2008)
28. Install the supplied tie strap, as shown in Figure 9, to secure the brake tube and tube connector to the vehicle.
29. Snap the new tube into the brake tube bundle clip (Figure 6).
30. If the rear brake tube is not being replaced, install the left front wheel opening plastic liner.
31. Lower the vehicle from the hoist.
32. Tighten the right brake tube flare nut at the HCU to 170 in.lbs. (19 N.m).
33. If the left rear brake tube is being replaced, continue with Section C - Replace the Left Rear Brake Tube. If the left rear brake tube is not being
replaced, continue with Section F - Replace Wheel Opening Liner Retainers.
C. Replace the Left Rear Wheel Brake Tube (Left Hand Drive)
1. If not previously removed, remove and save the left front plastic wheel liner.
