Wrangler 2WD V6-3.8L (2008)
1.
Place a fender cover at the top of the windshield and open the hood until it contacts the fender cover.
2.
Remove the engine air filter housing and throttle body fresh air connector hose.
3.
Remove and discard the plastic tie strap (if equipped) retaining the brake tubes to the right shock tower next to the steering column intermediate
shaft lower universal joint.
4.
Using a small mirror, inspect the two brake tubes located next to the steering column intermediate shaft lower universal joint (Figure 2).
>
If the steering column intermediate shaft lower universal joint has not rubbed against the brake tube(s), continue with Section C Install Brake
Tube Retaining Clip.
>
If one or both of the brake tubes have rub marks from contacting the steering column intermediate shaft lower universal joint, replace the brake
tube(s) that have rub marks. Continue with Section B - Replace Brake Tube(s).
B. Replace Brake Tube(S)
1.
Disconnect the negative battery cable from the battery.
2.
Unsnap the radiator coolant overflow bottle from the radiator and set aside.
NOTE:
Do not disconnect any of the hoses from the coolant overflow bottle.
3.
Remove the fastener that holds the power steering reservoir to the radiator core support and set the reservoir aside.
NOTE:
Do not disconnect any of the hoses from the power steering reservoir.
