Wrangler 2WD V6-3.8L (2008)
b.
Attach one end of bleed hose to bleed screw on the rear brake caliper and insert opposite end in a clear container partially filled with brake
fluid (Figure 6). Be sure that the end of bleed hose is fully immersed in brake fluid.
c.
Open the bleeder screw on the rear brake caliper that had the brake tube replaced, then have an assistant press and hold the brake pedal
down. Once the pedal is down, close the bleeder screw and release the brake pedal. Repeat the bleeding process until the brake fluid stream
in the container is clear and free of air bubbles.
d.
Repeat Steps 23a through 23c on the other rear brake caliper if both rear brake tubes were replaced.
24.
Continue with Section C - Install Brake Tube Retaining Clip.
C. Install Brake Tube Retaining Clip
1.
Snap the rear brake tubes into new brake tube retaining clip.
2.
Slide the new brake tube retaining clip forward so that the clip lines up with the existing hole in the shock tower.
