Wrangler 2WD V6-3.8L (2008)
5. Install the main bearing caps (1,2,3,5) and bolts. Tighten bolts to 41 Nm (30 ft. lbs.) plus 1/4 turn.
NOTE: Install new cross bolt and washer assembly upon reassembly.
6. Install and tighten the NEW cross bolts and washer assemblies (8) to 61 Nm (45 ft. lbs.).
7. Position and install the connecting rod and bearing caps on the crankshaft See: Connecting Rod Bearing/Service and Repair.
8. Install the crankshaft rear oil seal See: Crankshaft Seal Retainer/Service and Repair/Crankshaft Rear Oil Seal Retainer - Installation
9. Install the crankshaft sprocket See: Timing Components/Timing Chain/Service and Repair.
10. Install the timing chain and camshaft sprocket See: Timing Components/Timing Chain/Service and Repair.
11. Install the timing chain cover See: Timing Components/Timing Cover/Service and Repair.
12. Install the oil pick-up tube and oil pan See: Engine Lubrication/Oil Pan/Service and Repair/Removal and Replacement.
13. Install the engine assembly See: Service and Repair/Removal and Replacement/Engine - Removal.
