Wrangler 2WD V6-3.8L (2008)
1. Position a new mode control cable (2) to the right side of the HVAC air distribution housing (3) through the opening in the instrument panel
support.
2. Connect the mode control cable to the mode door cam (4).
3. Engage the metal retaining clip (1) to the right side of the HVAC air distribution housing. Make sure the retaining clip is fully engaged to the
housing.
4. Connect the mode door control cable to the A/C-heater control and install the instrument panel center bezel.
5. Visually verify the mode door cam moves from the full defrost position to the full panel position and then back to the full defrost position using
the mode control knob on the A/C-heater control. If OK, go to step 10. If not OK, proceed to step 6.
NOTE: Failure to adjust the mode control cable when required can result in operating modes not properly obtained.
6. Disengage the mode control cable from the metal retaining clip located on the right side of the HVAC housing.
7. Turn the mode control knob on the A/C-heater control to the full defrost position.
8. Reach behind the instrument panel and turn the mode door cam clockwise until it stops in the full defrost position and engage the mode control
cable to the metal retaining clip. Make sure the cam is in the full defrost position and that the cable is fully engaged to the retaining clip.
9. Verify the mode door cam moves from the full defrost position to the full panel position and then back to the full defrost position as selected with
the mode control knob on the A/C-heater control. If not, repeat steps 6 thru 9.
10. On LHD models, install the glove box.
11. Reconnect the negative battery cable.
