Wrangler 2WD V6-3.8L (2008)
Fuel Gauge Sender: Service and Repair
Removal
REMOVAL
WARNING: The fuel system is under a constant pressure (even with the engine off). Before servicing the fuel pump module, the fuel system
pressure must be released.
1. Drain and remove fuel tank.
2. Note rotational position of module before attempting removal. An indexing arrow is located on top of module for this purpose.
3. Position special Lockring Remover/Installer tool 9340 (3) into notches on outside edge of lockring (5).
4. Install 1/2 inch drive breaker bar (1) to special Lockring Remover/Installer tool 9340 (3).
5. Rotate breaker bar counter-clockwise to remove lockring.
6. Remove lockring. The module will spring up slightly when lockring is removed.
7. Remove module from fuel tank. Be careful not to bend float arm while removing.
