Wrangler 2WD V6-3.8L (2008)
Dome Lamp Bulb: Service and Repair
Installation
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
1. While holding the dome lamp housing bezel (3) flush with the rear speaker enclosure, align the ends of the bulb (4) with the two bulb holders
within the lamp housing (2).
NOTE: If the lamp housing is lowered from the mounting hole, the lamp MUST be reinstalled as per the installation procedure. See:
Service and Repair/Dome Lamp - Installation.
2. Carefully press the bulb firmly and evenly into the bulb holders until it snaps into place.
3. Swing the notched end of the lens (1) up into position against the housing, then press upward on the lens firmly and evenly until it snaps into place.
4. Reconnect the battery negative cable.
