Wrangler 2WD V6-3.8L (2008)
Fog/Driving Lamp Bulb: Service and Repair
Front Fog Lamp
Removal
BULB
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
1. Disconnect and isolate the battery negative cable.
2. For export market vehicles, turn the front wheels fully in either direction.
3. Raise and support the vehicle.
4. For domestic market vehicles equipped with the optional electronic sway bar disconnect feature, service of the right fog lamp bulb will also
require removal of the front bumper lower air dam from the vehicle.
5. From behind the front bumper (2), disconnect the engine compartment wire harness connector (4) from the front fog lamp bulb (3) connector
receptacle.
6. Firmly grasp the bulb on the back of the front fog lamp housing (1) and rotate it counterclockwise about 30 degrees to unlock it.
7. Pull the bulb straight out from the keyed opening in the housing.
Installation
BULB
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb
life will result.
