Wrangler 2WD V6-3.8L (2008)
Horn Switch: Service and Repair
Removal
REMOVAL
WARNING:
-
On vehicles equipped with airbags, refer to Restraint Systems, before attempting any steering wheel, steering column, or instrument
panel component diagnosis or service. Failure to take the proper precautions could result in accidental airbag deployment and possible
personal injury.
-
The horn switch is integral to the driver side airbag module. Service of this component should be performed only by Chrysler trained and
authorized dealer service technicians. Failure to take the proper precautions or to follow the proper procedures could result in accidental,
incomplete, or improper airbag deployment and possible occupant injuries.
1. Disconnect and isolate the battery negative cable.
2. Remove the trim cover from the driver side airbag. See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Removal and
Replacement/Driver Airbag.
3. Remove the mounting fasteners.
4. Disconnect the electrical connector.
5. Remove horn switches by gently rocking the switch side to side while pulling outwards.
