Wrangler 2WD V6-3.8L (2008)
c. Loose assemble the tow bar mounting brackets to the right and left side of the frame using the handle nuts and attachment bolts with spacers
(Figure 7).
CAUTION:
The spacers must be centered in both the frame and bracket holes. The spacers are properly center when there is no gap between the tow bar
mounting bracket and the frame or between the head of the bolt and the face of the tow bar mounting bracket (Figure 7).
d. Bend the tab of the handle nut until it lays flush with the tow bar bracket (Figure 8).
e. Pinch the tab of the handle nut between the tow bar bracket and the frame with a pair of vice grips (Figure 8).
f.
Tighten the tow bar mounting bracket attachment bolts to 85 ft. lbs. (115 N.m) (Figure 8).
g. Repeat steps 8 d. through 8 f. on the remaining three attachment bolts.
9. Position the front air dam on the vehicle by slipping the mounting flange of the air dam between the bumper cushions and the tow bar brackets
(Figure 4).
10. Install the four plastic push pins in the mounting flange of the air dam (Figure 4).
11. Install the two plastic push pins at the rear of the air dam (Figure 3).
