Wrangler 2WD V6-3.8L (2008)
e. Record the "Software Part Number" displayed at the end of the "Resident flash file for" statement near the top of "Flash CCN" screen for later
reference.
6. Download the flash file from the internet to the StarSCAN. With the StarSCAN on the "Flash CCN" screen, follow the procedure below:
a. Select "Browse for New File". Follow the on screen instructions.
b. If the newly downloaded flash file "Software Part Number" description:
>
is the same as the number recorded in Step 5e, then the CCN is up to date.
Continue with Step 9.
>
is different than the number recorded in Step 5e, then the CCN will require an update. Continue with Step 6c.
c. Highlight the listed calibration on the StarSCAN screen.
d. Select "Download to Scantool".
e. Select "Close" after the download is complete, then select "Back".
f.
Highlight the listed calibration.
g. Select "Update Controller" and follow the on screen instructions.
h. When the update is completed, select "OK".
7. Retrieve the CCN software part number. With the StarSCAN on the "Home" screen, follow the procedure below:
a. Select "ECU View".
b. Touch the screen to highlight "CCN Instrument Cluster/Cabin Compartment" in the list of modules.
c. Select "More Options".
d. Select "ECU Flash".
e. Verify the "Software Part Number" (displayed at the end of the "Resident flash file for" statement) has been updated to the new part number. If it
has updated, then the flash has been completed successfully.
8. Clear any Diagnostic Trouble Codes (DTCs) as follows:
NOTE:
Due to the CCN programming procedure, DTC(s) may be set in other modules (PCM, TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate.
a. From the "Home" screen select "System View".
b. Select "All DTCs".
c. Press "Clear All Stored DTCs" if there are any DTCs shown on the list.
9. Turn the ignition key to the "OFF" position and remove the StarSCAN unit, StarSCAN cable, and battery charger from the vehicle.
C. Reprogram the Ccn Using Starmobile
NOTE:
The CCN is "abort - recovery" supported. If this flash process is interrupted/aborted repeat the procedure.
1. Open the hood. Install a battery charger and verify that the charging rate provides 13.2 to 13.5 volts. Do not allow the charger to time out during the
flash process.
Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand-alone voltmeter. The battery charger voltmeter may not be sufficiently accurate. Voltages outside of the specified range will
