Wrangler 2WD V6-3.8L (2008)
SPECIAL TOOLS / EQUIPMENT REQUIRED:
REPAIR PROCEDURE:
SECTION A - REPLACE CAMSHAFT POSITION SENSOR:
1.
Disconnect and isolate the negative battery cable from the battery.
2.
Disconnect the camshaft sensor electrical connector (Fig. 1).
3.
Clean the area around the camshaft sensor and bore.
4.
Loosen the camshaft sensor mounting bolt.
5.
Remove the camshaft sensor from engine with a pulling and rotating motion.
6.
Verify that the old 0-ring on the camshaft sensor was removed with the old camshaft sensor.
7.
Apply a couple of drops of engine oil to the new camshaft sensor 0-ring.
NOTE: