Wrangler 2WD V6-3.8L (2008)
7.
Apply a small amount of antiseize to the threads of each spark plug.
CAUTION:
Do not over apply anti-seize compound. Only use enough to lightly coat threads on the spark plug.
8.
Using a quality spark plug socket with a rubber insert (Snap-on S9706KFUA or equivalent), start each spark plug into the cylinder head by hand.
9.
Tighten the spark plugs to 13 ft. lbs. (17 N.m).
10.
Install each of the spark plug wires over the spark plugs.
NOTE:
Each spark plug wire has the corresponding cylinder number
printed on it.
NOTE:
An audible click can be heard and felt when the spark plug cable
has been properly attached to the spark plug.
CAUTION:
Be sure that each spark plug wire location and routing is returned to its original position.
11.
Type or print (with a ballpoint pen) the necessary information shown in Figure 2 onto the Authorized Modifications Label. Then attach the label
near the VECI label.
12.
For California vehicles, this recall is subject to the State of California Registration Renewal/Emissions Recall Enforcement Program. Complete a
Vehicle Emission Recall Proof of Correction Form (Form No. 81-016-1053) and supply it to vehicle owners residing in the state of California for
proof that this recall has been performed when they renew the vehicle registration.