Wrangler 2WD V6-3.8L (2008)
1. Position the second row seat belt and retractor unit (4) to the base of the rear sport bar. Be certain to engage the tab on the upper retractor bracket
into the hole in the sport bar.
2. Install and tighten the screw (6) that secures the retractor lower bracket to the base of the rear sport bar. Tighten the screw to 40 Nm (30 ft. lbs.).
3. Position the second row seat belt turning loop (2) to the upper rear sport bar. Be certain the seat belt webbing between the retractor and the turning
loop is not twisted.
4. Install and tighten the screw (3) that secures the turning loop to the sport bar. Tighten the screw to 40 Nm (30 ft. lbs.).
5. Engage the upper edge of a new trim cover (1) over the top of the turning loop. Then squeeze the lower end of the trim cover and the turning loop
together firmly and evenly until the engagement tabs of the trim cover snap into the slots of the turning loop.
6. Position the second row seat belt (5) lower anchor onto the stud on the rear floor panel. Be certain the seat belt webbing between the turning loop
and the lower anchor is not twisted.
7. Install and tighten the nut (7) that secures the lower anchor to the stud on the rear floor panel. Tighten the nut to 40 Nm (30 ft. lbs.).
