Wrangler 2WD V6-3.8L (2008)
Seat Belt Buckle: Service and Repair
Seat Belt Buckle - Removal
Front
FRONT
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the
proper precautions could result in accidental airbag deployment.
WARNING: To avoid serious or fatal injury on vehicles equipped with the Occupant Classification System (OCS), do not modify the front
passenger seat assembly or center floor console in any way. Do not use any prior year, subsequent year, secondary or aftermarket seat trim
covers. At no time should any Supplemental Restraint System (SRS) or OCS component be modified or replaced with any part except those
which are specified for the particular vehicle application in the DaimlerChrysler Mopar(R) Parts Catalog. Failure to observe these precautions
could cause an OCS miscalibration condition, which may result in the passenger airbag failing to deploy when required or deploying when not
required.
WARNING: To avoid serious or fatal injury, never strike or drop a seat weight sensor or the passenger side front seat assembly to which the
sensors are secured as it can damage the sensors or affect their calibration. The seat weight sensors and the passenger side front seat assembly
must be handled with care to avoid damage to the sensors. Do not sit upon or place any loads upon a passenger side front seat while it is
removed from its mounts in or outside of the vehicle. If an individual sensor is dropped or damaged, replace the sensor with a new and unused
unit. If a seat has been dropped during removal or loaded while removed from its mounts, replace each of the seat weight sensors with new and
unused units. Failure to observe this warning could result in an accidental, incomplete, or improper passenger side front supplemental restraint
deployment.
1. Move the front seat to its middle position for easiest access to the front seat mounting provisions.
2. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
3. Remove the front seat from the vehicle. See: Body and Frame/Seats/Service and Repair/Seat - Removal.
4. Disengage the inboard seat cushion trim cover J-clip from the seat cushion trim wire, and pull the inboard side of the trim cover upward far enough
to access the front seat belt buckle lower anchor.
5. On the driver side only, disconnect the seat belt switch pigtail wire connector (4) from the seat wire harness.
6. Remove the screw (3) that secures the front seat belt buckle lower anchor to the inboard side of the front seat cushion frame (1).
7. Remove the seat belt buckle from the front seat cushion frame.
Second Row - Two Door
