Wrangler 2WD V6-3.8L (2008)
NOTE: The anchor plates for the right second row seat belt buckle (4) and the second row center seat belt anchor (1) are secured to each other
by a soft metal grommet as an assembly aid during the manufacturing process and, once removed, the grommet does not require reinstallation.
1. With the 60 percent second row seat back in the uptight position, engage the anchor plate and webbing for the right second row seat belt buckle
unit through the elastic loop integral to the seat cushion trim cover and between the seat back and cushion.
2. Fold the 60 percent second row seat back flat for easiest access to the right second row seat belt buckle (4) and the second row center seat belt
anchor (1) location.
3. Install and tighten the screw (3) that secures the anchor plates to the rear floor panel. Tighten the screw to 61 Nm (45 ft. lbs.).
4. Restore the 60 percent second row seat back to the uptight position.
Second Row - Center and Left - Four Door
SECOND ROW - CENTER AND LEFT - FOUR DOOR
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. With both second row seat backs in the uptight position, engage the anchor plate and webbing for the center or left second row seat belt buckle
unit through the elastic loop integral to the seat cushion trim cover and between the seat back and cushion.
2. Fold the 60 percent second row seat back flat for easiest access to the center seat belt buckle (1) anchor, or the 40 percent seat back flat for easiest
access to the left seat belt buckle (3) anchor.
3. Position the center or left seat belt buckle unit anchor plate onto the stud on the center seat bracket, hinge and latch unit (2).
4. Install and tighten the nut (4) that secures the buckle unit to the stud. Tighten the nut to 45 Nm (33 ft. lbs.).
5. Restore the second row seat back to the uptight position.
