Wrangler 2WD V6-3.8L (2008)
1. Adjust the front seat (1) to its most forward position for easiest access to the front seat belt (3) lower anchor and the B-pillar trim.
2. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
3. Remove the screw (2) that secures the lower anchor to the outboard side of the front seat cushion frame.
4. Unsnap the trim cover (4) from the front seat belt turning loop (2) and discard.
5. Remove the screw (3) that secures the seat belt turning loop to the height adjuster (1) on the upper B-pillar.
6. Remove the seat belt turning loop from the height adjuster.
7. Remove the lower trim (2) from the inside of the B-pillar (1). See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim.
8. Disengage the seat belt webbing (3) through the slot from the seat belt opening in the lower B-pillar trim.
9. Disconnect the yellow body wire harness connector (5) from the seat belt tensioner initiator on the retractor.
10. Remove the screw (4) that secures the lower retractor bracket to the B-pillar.
11. Remove the front seat belt and retractor from the B-pillar as a unit.
