Wrangler 2WD V6-3.8L (2008)
Crankshaft Position Sensor: Service and Repair
Installation
INSTALLATION
1. Clean out machined hole in transmission bellhousing.
2. Apply a small amount of engine oil to sensor o-ring.
3. Install sensor (2) into transmission with a slight rocking and twisting action.
CAUTION: Before tightening sensor mounting bolt (1), be sure sensor is completely flush to transmission bellhousing. If sensor is not
flush, damage to sensor mounting tang may result.
4. Install mounting bolt (1) and tighten to 28 Nm (21 ft. lbs.).
5. Connect electrical connector (3) to sensor.
6. Lower vehicle.
