Wrangler 2WD V6-3.8L (2008)
1. Thread decoupler pulley onto generator shaft by hand (right-hand threads).
2. Position Special Tool #8823 (VM.1048) (2) into decoupler.
3. Determine if end of generator shaft is hex shaped or is splined. If hex is used, insert a 10mmM deep socket (1) into tool #8823 (VM.1048) (2).
4. If splined, insert a 5/16" 6-point hex driver, or a 10mm 12-point triple square driver (1) into tool #8823 (VM.1048) (2).
5. Do not use an adjustable, ratcheting "click type" torque wrench. Most "click type" wrenches will only allow torque to be applied in a
clockwise rotation. Use a dial-type or beam-type wrench. Tighten in directions as shown. Refer to torque specifications.
6. Install accessory drive belt, and generator.
7. Connect negative battery cable.
Litens Decoupler