Wrangler 2WD V6-3.8L (2008)
10. Pull the module (1) straight out and off the retaining tabs (2) located on the lock cylinder housing.
Installation
INSTALLATION
NOTE: Ignition module must be installed prior to lock housing installation on column. Otherwise, the tilt lever will obstruct installation of
ignition switch.
1. Ensure the ignition module is in the RUN position and the actuator shaft in the lock housing is in the RUN position.
2. Align the ignition module with the pin (3), actuator shaft and retaining tabs (2) located on the lock cylinder housing. Carefully install the module,
snapping it into place over the retaining tabs.
3. Install the ignition module (2) mounting screw (1). Tighten the screw to 2 Nm (18 in. lbs.).
