Wrangler 2WD V6-3.8L (2008)
Front Steering Knuckle: Service and Repair
Front Steering Knuckle - Installation
INSTALLATION
1. Install the knuckle to the ball joint studs.
2. Install the upper ball joint nut and cotter pin. Tighten to
3. Install the lower ball joint nut and cotter pin. Tighten to
4. Install the wheel speed sensor (1) through the hole in the brake shield (2).
5. Install the axle shaft nut (if equipped). Tighten to 136 Nm (100 ft.lbs).
6. Install the wheel speed sensor (1) in the hub/bearing and tighten the bolt (2) to 4-6 Nm (34-50 in. lbs.).
