Wrangler 2WD V6-3.8L (2008)
Pressure Regulating Solenoid: Service and Repair
Installation
INSTALLATION
NOTE: If the Solenoid/Pressure Switch assembly is being replaced, the Quick Learn Procedure must be performed. See: Transmission Control
Systems/Testing and Inspection/Programming and Relearning/TCM Quick Learn
1. Install Solenoid/Pressure Switch Assembly (1) and screen (3) to the separator and transfer plates.
2. Install and tighten retaining screws (2) to 5.5 Nm (50 in. lbs.) torque.
3. Install valve body. See: Valve Body/Service and Repair/Removal and Replacement/Installation