Wrangler 2WD V6-3.8L (2008)
Valve Body: Removal and Replacement
Removal
REMOVAL
NOTE: If valve body is being reconditioned or replaced, it is necessary to perform the Quick Learn Procedure.See: Transmission Control
Systems/Testing and Inspection/Programming and Relearning/TCM Quick Learn
1. Disconnect the TRS and solenoid wiring connectors.
2. Disconnect the shift cable from the shift lever (at the transmission).
3. Move the manual shift lever clockwise as far as it will go. This should be one position past the L position. Then remove the manual shift lever.
NOTE: One of the oil pan bolts has a sealing patch applied from the factory. Separate this bolts for reuse.
4. Remove transmission pan bolts (2).
5. Remove transmission oil pan (1).
6. Remove oil filter (1) from valve body. It is held in place by two screws.
