Wrangler 2WD V6-3.8L (2008)
2. Install transmission oil filter (1).
NOTE: Before installing the oil pan bolt in the bolt hole (5) located between the torque converter clutch on and U/D clutch pressure tap circuits
, it will be necessary to replenish the sealing patch on the bolt using Mopar(R) Lock & Seal Adhesive.
3. Make sure oil pan (1) and case rail are clean and dry. Install an 1/8" bead of RTV to the transmission oil pan and install to case. Tighten bolts (2)
to 20 Nm (14.5 ft. lbs.).
4. Lower vehicle and connect the TRS connector.
5. Connect solenoid/pressure switch assembly connector.
6. Lower vehicle.
7. Fill transmission with ATF+4, Automatic Transmission Fluid. Verify proper fluid level. See: Service and Repair/Procedures/Transmission Fill -
42RLE
NOTE: If the valve body has been reconditioned or replaced, it is necessary to perform the Quick Learn Procedure. See: Transmission
Control Systems/Testing and Inspection/Programming and Relearning/TCM Quick Learn
