Wrangler 2WD V6-3.8L (2008)
NOTE: Clean all propeller shaft bolts and apply Mopar(R) Lock & Seal Adhesive or equivalent to the threads before installation.
1. Compress the propeller shaft enough to install it into the axle flange and transmission/transfer case flange.
2. Align installation reference marks on the transmission/transfer case flange (1) and propeller shaft transmission/transfer end CV joint (2).
3. Install propeller shaft CV joint retainers (2) and bolts (1). Tighten bolts to 20 Nm (15 ft. lbs.).
