Wrangler 2WD V6-3.8L (2008)
Chrysler Group LLC
Information
Use one of the three scan tools below to perform this recall.
A. Reprogram the CCN Using wiTECH
NOTE:
The CCN is "abort - recovery" supported. If this flash process is interrupted/aborted repeat the procedure.
1. Open the hood. Install a battery charger and verify that the charging rate provides 13.2 to 13.5 volts. Do not allow the charger to time out during the
flash process. Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand-alone voltmeter. The battery charger voltmeter may not be sufficiently accurate. Voltages outside of the specified range will
cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower motor
to lower the voltage.
2. Connect the wiPOD to the vehicle data link connector.
3. Place the ignition key in the "RUN" position.
4. Launch the wiTECH diagnostic application.
5. Select "CCN" from the vehicle view screen.
6. Select the "FLASH" tab.
7. Select the flash file from the list.
8. Select the "UPDATE ECU" button and follow the screen prompts.
9. Clear all DTC's.
NOTE:
Due to the CCN programming procedure, DTC(s) may be set in other modules (PCM, TCM, ABS, BCM, MIC, WCM, etc.) within the vehicle, if so
equipped. Some DTC's may cause the MIL to illuminate.
10. Place the ignition in the "OFF" position, remove the wiPOD from the data link connector and disconnect the battery charger.
B. Reprogram the CCN Using Starscan
NOTE:
The CCN is "abort - recovery" supported. If this flash process is interrupted/aborted repeat the procedure.
1. Open the hood. Install a battery charger and verify that the charging rate provides 13.2 to 13.5 volts. Do not allow the charger to time out during the
flash process. Set the battery charger timer (if so equipped) to continuous charge.
NOTE:
Use an accurate stand-alone voltmeter. The battery charger voltmeter may not be sufficiently accurate. Voltages outside of the specified range will
cause an unsuccessful flash. If voltage reading is too high, apply an electrical load by activating the park or headlamps and/or HVAC blower motor
to lower the voltage.
2. Connect the CH9410 StarSCAN ethernet cable to the StarSCAN and the dealer's network drop.
3. Connect the CH9404D StarSCAN vehicle cable to the StarSCAN and the vehicle data link connector.
4. Place the Ignition in the "RUN" position, then Power "ON" the StarSCAN.
5. Retrieve the old CCN software part number. With the StarSCAN on the "Home" screen, follow the procedure below:
a. Select "ECU View".
b. Touch the screen to highlight "CCN Instrument Cluster/Cabin Compartment" in the list of modules.
c. Select "More Options".
d. Select "ECU Flash".
