Wrangler 2WD V6-3.8L (2008)
Wiper Blade: Service and Repair
Wiper Blades - Installation
Front
FRONT
CAUTION: Do not allow the wiper arm to spring back against the glass without the wiper blade in place or the glass may be damaged.
NOTE: The notched end of the wiper element flexor should always be oriented towards the end of the wiper blade that is nearest to the wiper
pivot.
1. Lift the wiper arm (2) off of the windshield glass, until the wiper arm hinge is in its over-center position.
2. Position the wiper blade near the hook formation (5) on the tip of the arm with the notched end of the wiper element flexor oriented towards the
end of the wiper arm that is nearest to the wiper pivot.
3. Insert the hook formation on the tip of the arm through the opening in the blade superstructure (1) ahead of the pivot block (3) far enough to
engage the pivot block into the hook.
4. Slide the pivot block up into the hook formation on the tip of the wiper arm until the latch release tab (4) snaps into its locked position. Latch
engagement will be accompanied by an audible click.
5. Gently lower the wiper blade and element (6) onto the glass.
Rear
REAR
CAUTION: Do not allow the wiper arm to spring back against the glass without the wiper blade in place or the glass may be damaged.
1. Lift the wiper arm (2) off of the lift glass.
2. Position the wiper blade (1) under the tip of the wiper arm, aligning the pivot pin near the center of the blade superstructure with the latch features
on the underside of the tip of the arm.
3. Squeeze the arm and blade together until the blade pivot pin snaps into the latch features of the arm.
4. Gently lower the wiper blade and element onto the glass.