Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Radio Connections - Typical
10.
Pull the radio out from the instrument panel far enough to access the wire harness connectors and the antenna coaxial cable connector.
11.
Unplug the wire harness connectors and the antenna coaxial cable connector from the rear of the radio.
12.
Remove the screw that secures the ground strap to the radio chassis.
13.
Remove the radio from the instrument panel.
14.
Reverse the removal procedures to install. Tighten the radio mounting screws to 5 N.m (45 in. lbs.). Tighten the instrument panel center bezel
mounting screws to 2.2 N.m (20 in. lbs.).
