Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Speaker: Service and Repair
Instrument Panel
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
Instrument Panel Speaker Bezel Remove/Install
2. Remove the two screws that secure the outboard end of the speaker bezel to the instrument panel.
3. Using a trim stick or another suitable wide flat-bladed tool, gently pry at the top and bottom edges of the speaker bezel to release the two snap clip
retainers that secure the bezel to the instrument panel.
4. Remove the speaker bezel from the instrument panel.
5. Remove the foam rubber speaker baffle from the speaker.
Instrument Panel Speaker Remove/Install
6. Remove the four screws that secure the speaker to the instrument panel armature.
7. Pull the speaker away from the instrument panel far enough to access the speaker wire harness connector.
8. Unplug the wire harness connector from the speaker.
9. Remove the speaker from the instrument panel.
10. Reverse the removal procedures to install. Tighten the speaker mounting screws to 1.1 N.m (10 in. lbs.). Tighten the speaker bezel mounting
screws to 2.2 N.m (20 in. lbs.).
