Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
3.
Install the isolator over the seat frame as shown in Figure 1. Attach the isolator to the frame at the locations as shown( See Figure 2). Hog rings
can be used for this. If hog rings are not available, pierce holes in the material and use nylon tie straps. The isolator needs to be attached to the
frame to prevent movent which might occur as the operator enters and exits the vehicle.
4.
Install the seat cover.
5.
Lubricate the seat track using white lithium spray grease such as MOPAR p/n 04318066 or equivalent. Make sure to apply lubricant to the seat
stops at the rear of the track.
6.
Install the seat and tighten the outboard bolts to 33 Nm (25 ft. lbs.). Tighten the inboard bolts to 47 Nm (35 ft. lbs.). Tighten the nuts to 33 Nm (25
ft.lbs.).
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
23-20-36-93
0.5 Hrs.
FAILURE CODE:
P8 - New part
