Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Acceleration/Deceleration Sensor: Service and Repair
REMOVAL
1. From the drivers side lift carpet back in front of the console/shifter.
2. Disconnect harness for switch.
Acceleration Switch
3. Remove mounting bolts and remove switch.
INSTALLATION
Acceleration Switch Position Indicator
CAUTION: The mercury switch (inside the acceleration switch), will not function properly if the switch is installed incorrectly. Verify that the
switch locating arrow is pointing to the front of the vehicle.
1. Position switch on mounting bracket.
2. Install mounting bolts and tighten to 4 - 5 Nm (35 - 45 inch lbs.)
3. Connect harness to switch.
4. Place carpet back into position
