Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Fig. 6
1. Remove brake lines that connect master cylinder to combination valve.
2. Disconnect brake lines that connect combination valve to the Hydraulic Control Unit (HCU).
3. Disconnect wire from combination valve switch terminal. Be careful when separating wire connector as lock tabs are easily damaged if not fully
disengaged.
4. Remove nuts attaching combination valve bracket to booster studs and valve bracket off booster studs.
Installation
1. Position valve bracket on booster studs and tighten bracket attaching nuts to 17 Nm (13 ft. lbs.).
2. Align and staft brake line fittings in combination valve, master cylinder and HCU by hand to avoid cross threading.
3. Tighten brake line fittings at combination valve to 21 Nm (15 ft. lbs.).
4. Tighten brake line fittings at master cylinder to 15 Nm (11 ft. lbs.).
