Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Electronic Brake Control Module: Service and Repair
REMOVAL
1. Remove negative battery terminal.
Controller Antilock Brakes
2. Remove the harness connector from the Controller Antilock Brake (CAB) located underneath the instrument panel.
3. Remove mounting bolt and remove the CAB.
INSTALLATION
1. Install the controller and install the mounting bolt.
2. Tighten the mounting bolt to 7 - 9 Nm (60 - 80 inch lbs.).
3. Plug in the harness connector into the controller.
4. Install negative battery cable.
