Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Blower Motor Resistor: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Remove the kick cover from the heater-A/C housing. See Kick Cover for the procedures.
Blower Motor Resistor Remove/Install
3. Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch.
4. Depress the latch on the blower motor resistor wire harness connector and unplug the connector from the resistor.
5. Remove the two screws that secure the resistor to the heater-A/C housing.
6. Remove the resistor from the heater-A/C housing.
7. Reverse the removal procedures to install. Tighten the mounting screws to 2.2 N.m (20 in. lbs.).
