Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Clutch Pulley Install
4. Install the pulley bearing assembly with the installer (Special Tool C-6871). Thread the installer on the shaft, then turn the nut until the pulley
assembly is seated.
5. Install the external front snap ring with snap ring pliers. The bevel side of the snap ring must be facing outward. Press the snap ring to make sure it
is properly seated in the groove.
CAUTION: It the snap ring is not fully seated in the groove it will vibrate out, resulting in a clutch failure and severe damage to the front housing
of the compressor.
6. Install the compressor shaft key and the original clutch shims on the compressor shaft.
Clutch Plate Driver
7. Install the clutch plate with the driver (Special Tool C-6463). Install the shaft hex nut and tighten to 14.4 N.m (10.5 ft. lbs.).
Check Clutch Air Gap
8. Check the clutch air gap with a feeler gauge. If the air gap does not meet the specification, add or subtract shims as required. The air gap
