jeep Workshop Repair Guides

Jeep Workshop Service and Repair Manuals

Steering/Suspension - Alignment Specification Revision|Page 718 > < Steering/Suspension - Alignment Specification Revision|Page 716
Page 2
background image

Install Ball Joint - One Side
02-10-60-90

3.5 Hrs.

Install Ball Joint - Both Sides
02-10-60-91

4.2 Hrs.

FAILURE CODE: P8 - New Part

Repair Procedure

Set the vehicle up on the alignment rack and check the alignment against the specifications listed in the applicable service manual. The specifications
shown below are specific targets, which will provide the optimum performance for the vehicles listed above. The only adjustments, which can be made
with the original factory equipment, were caster, toe in and steering wheel center. 1999 and 2000 Grand Cherokee (WJ), caster adjustment was not
provided. The new ball joints will offer adjustments of up to 1.5 degrees for camber and caster where required.

Alignment Specifications (Degrees)

Steering/Suspension - Alignment Specification Revision|Page 718 > < Steering/Suspension - Alignment Specification Revision|Page 716